Tara System Forklift/Loader Hydralic Scale System/Thermal Printer/Pressure

Description

Model TR-1-NK-HE hydraulic weighing system Forklift / Loader Hydraulic, Made in USA Complete with Hydraulic Pressure Sensor and all wiring “T” fitting (not included) Thermal Printer included Full feature digital scale system for lowest cost. Made in U.S.A. at our San Diego plant. Complete system for any hydraulic lifting equipment. The unit has adjustable parameters for automatic weight capture and capture and add for front-end-loaders. Display modes for display of Current Load or Total Weight. Printer data output for recording each load and total. The readout built -in printer/ receipt printer. Preliminary Testing and Calibration: The system will weigh accurately only in the first stage on a truck that has multiple telescoping lift cylinders. A weighing height must be established and the best method to reach the weighing height must be determined. Setting zero, as well as weighing a load, must all be done in the same manner. Repeatability is the key to accurate weighments. We will use a method of lifting then lowering a few inches to the set height, but if lifting to the height without lowering gives better results, then do it that way. You will need to have a known weight available that is evenly distributed The weight should be at least 40% of the lifts capacity, but if it is not available, a lesser weight can be used. 1. Assure that the mast is not tilted, then raise the forks to aprox. 16 inches above ground level. NOTE: On loaders, the height should be at the height that would be used to load into a truck. 2. Use a piece of tape to make a mark on the mast and the carriage so the lift height can be seen and repeated easily by the lift operator. 3. Lower the lift back to the ground, then lift to aprox. 2 inches over the tape marks, then jog the lift down to the marks. 4. Press and hold the PRINT button in while turning the power on. 5. When the display shows —— release the PRINT button. 6. Press and release the TOTAL butto